Browse Client Types

Browse past lab clients by general industry sectors

Trial Number 0

Trial Purpose:

Determine the effectiveness of removing light oils

Date Run:

03/08/1995

Experiment Procedure:

The parts will be cleaned in a Crest Ultrasonic unit.  Part #2 was cleaned for 4 minutes and parts #3 and #4 were cleaned for 10 minutes.  The cleaner bath temperature was set at 140 F.  Half of the cleaning time was done with the hole side up while the other half was done with the hole side down so that both the interior and the exterior would be subjected to ultrasonic energy.  The parts were then washed in a tap water rinse and then a DI water rinse, both for 2 minutes at 140 F.  The parts were then dried under an IR lamp for 25 minutes and then in a convection oven for 30 minutes.

                                                                                                       Temperature   

  time (min)  sample #2  sample #3 sample #4

 

Ultrasonics

 

4, 10, 10

 

144

 

144

 

144

 

#1 RINSE/TAP H2O

 

2

 

138

 

145

 

141

 

#2 RINSE/DEIONIZED H2O

 

2

 

138

 

142

 

138

 

DRY- IR lamps

 

30

 

104

 

105

 

104

 

DRY convection oven

 

30

 

135

 

139

 

134

Trial Results:

Part #2-   A lot of oil dragout was noticed in both rinse tanks, so cleaning time was increased to ten minutes.  Water was noticed on the part after 30 minutes under the IR lamp. After 30 minutes in the convection oven, there was still some water remaining on the part.  Parts #3 and #4- Excellent removal of oil on both the inside and outside of the tubes. No oil dragout was noticed in the rinse tanks suggesting that all oil was removed in the cleaning bath.  Once again, drying was incomplete.

Success Rating:

Test incomplete or inconclusive.

Conclusion:

A cleaning time of ten minutes seems sufficient to remove all of the oil.  Due to the large surface area, the parts take a long time to dry.  The shortest drying time would probably be achieved by using a vacuum oven after the hot rinse.

Save Report as a PDF