Browse Client Types

Browse past lab clients by general industry sectors

Trial Number 2

Trial Purpose:

To identify alternatives for second contaminant (509)

Date Run:

08/13/2001

Experiment Procedure:

Eight cleaners were selected based on previous testing and based on vendor information. The aqueous based products were diluted to 10% using DI water in 250 ml beakers. The other solutions were used at full strength. All products were heated to 140 F on a hot plate. Twenty-four pre-weighed ceramic coupons were coated with the Crystalbond 509. The coating was heated with a hot air gun and wiped across the coupons using a glass rod. The coating was allowed to cool to room temperature and the coupons were weighed again. Three coupons were immersed in each beaker and allowed to soak for 10 minutes. Coupons were rinsed in a DI water spray for 1 minute at room temperature and dried using air blow off.

Trial Results:

After the initial 10 minute soak, none of the solutions were effective in removing the coating. Two products, D Greeze 500 Lo and Safety First were moderately successful. The appearance of the coating was changed and the D Greeze coupons were sticky. The increased cleaning time improved the effects the cleaners had on the coating. Luminox, Polysray Jet 790 XS and SC Supersolve showed the most changes with the longer cleaning.

Cleaner Coupon 1 Coupon 2 Coupon 3 Average Std Dev
Bio T Max -0.75 -1.27 -2.37 -1.46 0.83
D Greeze 12.22 0.59 35.96 16.26 18.02
Safety First 2.34 -1.02 38.52 13.28 21.92
Soy Gold -20.47 -15.89 -13.13 -16.5 3.71
Bio T 200 A -11.22 -16.9 -5.26 -11.13 5.82
SC Supersolve 86.46 40.87 80.23 69.19 24.72
Polyspray 12.14 89.07 65.86 55.69 39.46
Luminox 46.27 85.58 7.18 46.34 39.2

The negative cleaning efficiencies appears to be due to the absorption of the cleaning solutions into the contaminant.  This process, overtime, would cause the contaminant to be removed from the substrate.

Success Rating:

Results successful using TACT (time, agitation, concentration, and temperature, as well as rinsing and drying) and/or other cleaning chemistries examined.

Conclusion:

The aqueous products at long cleaning times and elevated temperature appears to be effective in removing the coating from the ceramic coupons.  The next test will be to further evaluate the diluted samples at a higher concentration to determine if their efficiencies can be increased.

Save Report as a PDF