Browse Client Types

Browse past lab clients by general industry sectors

Trial Number 0

Trial Purpose:

To determine a replacement for ink removal

Date Run:

07/08/1997

Experiment Procedure:

Eight steel coupons were weighed after preclean treatment. The coupons were then contaminated with an excess amount of ink. The drying process was sped along through the use of an oven set at 100 C for approximately one hour.
Eight cleaning chemistries (including the customer supplied cleaner) were tested to determine an appropriate replacement. Paper towels were used to apply the cleaners. The time to remove the ink was recorded. In order to keep the experiment practical, a cut off time of five minutes was used. Once the ink was removed, a dry paper towel was used to remove the excess cleaner and ink residue. The samples were allowed to sit overnight and were then reweighed to determine their effectiveness at removing the ink.
SUBSTRATE MATERIAL: stainless steel
CONTAMINANTS: ink---Steel Blue DX-100 solvent based dye
CONTAMINATING PROCESS USED: manual application of ink, dry for 1 hour at 100 C

Trial Results:

Of the eight chemistries used, only three showed success in removing the ink.  Cleaner number one (cleaner to be replaced) was completely successful in removing the ink.  It should be noted that the weight of the coupon after treatment with cleaner number 1 was lower than the pre-cleaned coupon, which may indicate substrate damage.  Of the remaining two, number 7 produced a lot of foam and would not be useful to the client.  Cleaner number 2 was a terpene based cleaner and had marginal result; however, the cleaner did not produce any foam.  The remaining chemistries had no positive cleaning effects.

coupon #   remaining  %cont. comments
  wt contam contaminate remaining  
1 0.0225 -0.0017 -7.56 damage
2 0.0200 0.0135 67.50  
3 0.0114 0.0174 152.63  
4 0.0112 0.0118 105.36 foamy
5 0.0107 0.0099 92.52 foamy***
6 0.0128 0.0140 109.38 foamy
7 0.0181 0.0089 49.17 foamy
8 0.0093 0.0093 100.00 foamy

***some of cleaner #1 cleaned a spot on coupon.  #1 was splashed on during experiment,  thus removing some of the ink.

Success Rating:

Test showed little or no promise.

Conclusion:

Of the eight chemistries tested, only three showed success in cleaning the ink from the coupons. One cleaner was the client supplied cleaner to be replaced, another produced unwanted foaming action and the final one did not clean a majority of the ink from the coupon.
It was determined from these results to run another experiment using terpene based cleaners that have ink cleaning capabilities.

Save Report as a PDF