Browse Client Types

Browse past lab clients by general industry sectors

Trial Number 2

Trial Purpose:

The pupose of this experiment was to verify the effectiveness of cleaners after compatibility testing.

Date Run:

01/14/2021

Experiment Procedure:

Compatibility testing was conducted before the experiment to ensure cleaners were compatible and not damaging the aluminum substrates. Pieces of aluminum foil were cleaned through the same process as coupons would be, but without soil. All cleaners were determined to be compatible with aluminum. Cleaners were prepared to the following concentrations: Metalnox 6386 100%, Dimethyl Glutarate 100%, SC Aircraft & Metal Cleaner 20%, Crystal Simple Green Industrial 30 parts water. SC Aircraft & Metal was heated to 100°F while the rest remained at room temperature. Three aluminum coupons were obtained and weighed for each of the cleaners being tested. Coupons were then soiled with V-4B oil and a dirty weight was recorded. Once solutions reached the proper temperature, coupons were submerged into their respective cleaners for 15 minutes. After 15 minutes, coupons cleaned with SC Aircraft were submerged into a deionized water bath at 100°F for 30 seconds. All coupons were then dried with a heat gun to remove excess solution and allowed to finish drying in air for 24 hours. Following the drying step, coupons were weighed and a clean weight was recorded. Effectiveness of the cleaners was determined.

Trial Results:

Cleaner Initial wt of cont Final wt of cont %Cont Removed %AVG
Metalnox 6386 0.0140 -0.0024 117.14 109.35%
0.0147 -0.0008 105.44
0.0128 -0.0007 105.47
Dimethyl Glutarate 0.0112 -0.0010 108.93 107.68%
0.0096 -0.0011 111.46
0.0113 -0.0003 102.65
SC Aircraft & Metal 0.0081 -0.0007 108.64 124.09%
0.0062 -0.0005 108.06
0.0072 -0.0040 155.56
Crystal Simple Green 0.0069 -0.0010 114.49 109.98%
0.0049 -0.0005 110.20
0.0057 -0.0003 105.26

All cleaners were effective at removing the oil from aluminum substrates. However, % removals have exceeded 100. There was no visual damage to the coupons at any stage in the cleaning process. Additionally, prior compatibility testing ensured that these cleaners are not stripping the aluminum coupons. Solutions have also mostly retained their original clear colors, with a hint of cloudiness due to the removal of the oil. While optimal testing conditions have been determined, total time of cleaning still requires optimization to get % removals at or just below 100. Next steps would be to test effectiveness after 10 minutes of immersion.

Success Rating:

Results successful using TACT (time, agitation, concentration, and temperature, as well as rinsing and drying) and/or other cleaning chemistries examined.

Conclusion:

All cleaners were effective at removing the oil, however, % removals remain above 100. The total time to clean could be too long leading to the increased removal values. Next steps would be to test effectiveness after 10 minutes of immersion to determine an optimal cleaning time.

Save Report as a PDF