Browse Client Types

Browse past lab clients by general industry sectors

Trial Number 3

Trial Purpose:

Evaluation of Oakite Inproclean 3800

Date Run:

05/11/1995

Experiment Procedure:

Coupons were cleaned and dried with a heat gun to get the clean weight.  A total of nine coupons were contaminated with contaminants #1, #2 and #4.  #3 was omitted because of lack of coupons and this appears to be the easiest contaminant to remove.  The coupons were then weighed after contamination.  Cleaning was done in an agitated stirbar beaker at 140 degrees for 5 minutes.  The parts were then rinsed in tap water at 140 degrees for 5 minutes.  Drying was done under the air knives for 2 minutes and then placed in an oven set at 216 degrees for 90 minutes.

Trial Results:

Lapping compound cleaned at 142 degrees, some removal by aggitation alone, very easy to remove contaminant by brushing for about 15 seconds. Vavoline grease cleaned at 146 degrees. Residual lapping compound in the cleaner seems to be clinging to the grease at first, but after a few minutes, you can see the grease being removed. Excellent removal of grease upon cleaning and rinsing. The Oakite cleaner is doing an excellent job of removing the Selmer oil. It appears one of the coupons was quite dirty after cleaning (the other two looked clean), this is probably due to the lack of aggitation it recieved.

TURI SURFACE CLEANING LAB EXPERIMENTAL DATA LOG
GRAVIMENTRIC ANALYSIS

sample # and contaminant clean weight (g) weight with contamination (g) weight after cleaning (g) weight change (g)  % Removal
5881, cont. #1  34.5897  34.9895  34.5895  0.40  100
4080, cont. #1  34.4089  34.6598  34.4089 0.2509  100
4401, cont. #1  34.4408  34.7038  34.4408  0.263  100
4317, cont. #2  34.4315  34.5241  34.4324  0.0917  99
4470, cont. #2  34.4474  34.5255  34.448  0.0775  99.2
7399, cont. #2  34.7364  34.8441  34.7406  0.1035  96.1
5330, cont. #4  34.5332  34.6049  34.5352  0.0697  97.2
4801, cont. #4 34.4806  34.5507  34.5149  0.0358  51.1
1803, cont. #4  34.1814  34.2687 34.1827  0.086  98.5

Cont. #1- Clover Grease Mix Lapping Compound
Cont. #2- Valvoline Wheel Bearing Grease
Cont. #3- 90 Wt Gear Oil
Cont. #4- Selmer Tuning Slide and Cork Grease

Success Rating:

Results successful using TACT (time, agitation, concentration, and temperature, as well as rinsing and drying) and/or other cleaning chemistries examined.

Conclusion:

The Oakite 3800 was the best cleaner overall with a percentage removal of contaminants ranging from 100 to 51 percent. The 51 percent achieved on coupon 4801 was due to the lack of agitation this part received.
Due to the success of this trial, Oakite 3800 will be used on the next trial for Musical Instrument Re-finisher when the parts from Musical Instrument Re-finisher will be cleaned with beaker agitation. This time contaminant #3 will be used and we are considering cleaning off the pieces with a cloth instead of a brush to protect the surface.

Save Report as a PDF